Allied Telesis AT-S63 - Manual (Page 350)

Chapter 22: GARP VLAN Registration Protocol
350 Section V: Virtual LANs
Configuring GVRP
To configure GVRP, perform the following procedure:
1. From the Home page, select Configuration.
2. From the Configuration menu, select the Layer 2 option.
3. Select the GVRP tab.
The GVRP tab is shown in Figure 136.
Figure 136. GVRP Tab (Configuration)
4. In the GVRP Parameters section, configure the following parameters
as necessary.
Note
The settings for the three timers must be the same on all GVRP-
active network devices.
Enable GVRP
Click to enable or disable GVRP.