Allied Telesis AT-S63 - Manual (Page 314)

Chapter 20: Multiple Spanning Tree Protocol
314 Section IV: Spanning Tree Protocols
Configuring MSTP
This section contains the following procedures:
ˆ “Configuring MSTP Parameters,” next
ˆ “Configuring the CIST Priority” on page 317
ˆ “Managing MSTIs” on page 318
ˆ “Configuring MSTP Port Parameters” on page 322
Note
MSTP must be selected as the active spanning tree protocol on the
switch before you can configure it. For instructions on selecting the
active spanning tree, refer to “Enabling MSTP” on page 312.
Note
When MSTP is enabled, the GVRP tab is not shown on the
Configuration or Monitoring Layer 2 page.
Configuring
MSTP
Parameters
To configure MSTP parameters, perform the following procedure:
1. From the home page, select Configuration.
2. From the Configuration menu, select the Layer 2 option.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 113 on page 292.
4. Click Configure.
The expanded MSTP Spanning Tree tab is shown in Figure 125.