Ericsson LBI-39224 - Manual (Page 122)

LBI-39224
3-92
Configurable Sites:
The Configurable Sites list box displays all unconfigured site-type
interface modules. If a CTIM appears in this box, no channel
configuration exists at the CEC/IMC Manager and no active Controller
Board control data link exists at the CEC/IMC for the corresponding
site assignment number. Any number of these available CTIMs may be
selected at one time to be added to the Configured/Active Sites list box
for configuration.
Configured/Active Sites:
The Configured/Active Sites list box displays CTIMs which have been
added but not yet channel-configured, CTIMs which have had previous
channel configurations performed, and CTIMs which have been
previously channel-configured and have an active Controller Board
control data link. Before any site-type interface module can be channel-
configured, it must be listed in the Configured/Active Sites list box.
Any number of the available CTIMs in this list may be selected at one
time for modification in the
Site Channel Configuration dialog box.
All selected CTIMs in this list will also be listed in the " Save As… "
dialog box that is accessed from the Site Channel Configuration
dialog box. If necessary, refer to Configured/Active Sites Prefix
Definitions, Table 1, on page 3-25 for an explanation of the prefixes.
Add
Choose the Add button to move a selected site from the Configurable
Sites list box and "add" it to the Configured/Active Sites list box where
it can be configured. If upon adding a site, a configuration data file
exists on the CEC/IMC Manager's hard disk drive from a previous add
and delete, the site will be added to the Configured/Active Sites list box
with its configuration data file (with a ** prefix). This previous
configuration may be modified, saved, and sent as needed.
Modify
Choose the Modify button to display the Audio Interface Type dialog
box. Select Audio Board to activate the Site Channel Configuration
dialog box, T1/E1 Interface is not supported for CTIMs. Audio Board
configuration is discussed in detail in the subsequent section.
Delete
Choose the Delete button to remove ("delete") a selected configured or
unconfigured CTIM from the Configured/Active Sites list box to the
Configurable Sites list box. Configured-and-active CTIMs cannot be
"deleted." This delete function does not remove channel configuration