Ericsson LBI-39224 - Manual (Page 141)

LBI-39224
3-111
configuration prior to sending it to the CEC/IMC because a send will
send the last configuration that was saved to disk; saving first ensures
that the actual CEC/IMC channel configuration will be the same as the
channel configuration stored on the CEC/IMC Manager hard disk. To
save and send configurations, action is required first in the
Console Channel Configuration dialog box and then in the
Console Channel Configuration List dialog box.
Console Channel Configuration dialog box
Save
Choose the Save button to perform an immediate save of the currently
selected console interface module's channel configuration. Other
consoles displayed in the list box located at the top of the dialog box
are not saved. This channel configuration is saved on the CEC/IMC
Manager's hard disk drive. Any previous channel configuration for the
console, if present, is erased and replaced with the current channel
configuration. If the CEC/IMC Manager is running remotely or as part
of the EDACS Network Manager, this configuration is saved on the
CEC/IMC Manager server, typically local to the CEC/IMC; it is not
saved at the remote location.
Save As...
Choose the Save As… button to allow the currently selected console
interface module channel configurations to be saved as a different
console interface module. This function is provided to speed
configurations when similar console configurations are required. Upon
choosing
Save As… a small dialog box, (see Figure 17 on page 3-34),
will appear which allows selection of a new console number. Select the
desired console number from one of the choices in the drop-down list
box, the choices listed are the selected consoles in the
Configured/Active Consoles list box. Like
Save , Save As… stores
channel configuration on the CEC/IMC Manager server.
Close
Choose the Close button to exit the Console Channel Configuration
dialog box and return to the Console Channel Configuration List
dialog box. If any changes have been made and not saved, you will be
prompted (
Write Changes to Disk? ) to save and exit ( Yes ), exit
without saving ( No ), or cancel the Close command and remain in the
dialog box ( Cancel ).