Ericsson LBI-39224 - Manual (Page 198)

LBI-39224
3-168
Figure 36 Tone Controlled Station State Table Mapping Dialog
Box
Help
Choose the Help button to access the Help function. (Help is also
available by pressing the F1 key.)
The Tone Controlled Station State Table Mapping (low level
configuration) dialog box maps to a state table located on the CI Board
for the selected channel. This state table is what the CI Board uses to
control the base station. Programming the state tables configures the
CEC/IMC to send the tone control signal that matches the conventional
base station configuration for the desired function. It will not be
possible to program state tables at the CEC/IMC without knowing the
corresponding base station's tone control signal configuration. Tone
stations' commands are controlled with Secur-It™, function, and hold
(PTT only) tones. There is no real definition of current state, so
regardless of the "current state" of the station, the same tone will always
be generated for a requested command.
The currently selected channel (selected previously in the
Conventional Channel Configuration dialog box) is displayed in the
read only Channel field with its associated Channel Alias displayed
below.