Ericsson LBI-39224 - Manual (Page 56)

LBI-39224
3-26
Interface Board will activate the T1/E1 Digital Site Configuration
dialog box. These options are discussed in detail in subsequent
sections.
Delete
Choose the Delete button to remove ("delete") a selected configured or
unconfigured site from the Configured/Active Sites list box to the
Configurable Sites list box. Configured-and-active sites (C/A prefix)
cannot be "deleted." This delete function does not remove "site"
channel configuration files from the CEC/IMC Manager's hard disk
drive. Therefore, if the "deleted" site is subsequently added back to the
Configured/Active Sites list box using the
Add button, the previous
channel configuration is not lost (this configuration data must be re-
saved in the
Site Channel Configuration dialog box before it can be
resent to the CEC/IMC).
Close
Choose the Close button to exit the dialog box and return to the main
menu. Any "**" (unconfigured and unsaved) sites appearing in the
Configured/Active Sites list box will be removed and returned to the
Configurable Sites list box.
Audio Interface Type Selection
For those site-type interface modules that may be equipped with either
an Audio Board or T1/E1 Interface Card (currently only MIMs, NIMs,
and PIMs may be so equipped), the audio interface type must be
selected before channel configuration can continue.
In the Site Channel Configuration List dialog box select the desired
site-type interface modules to configure from the Configured/Active
Sites list, or add the desired modules from the Configurable Sites list, if
not already listed, as described earlier. Choose
Modify to display the
Audio Interface Type dialog box, select either the Audio Board option
button or the T1/E1 Interface Board option button, then choose OK to
continue. Choose the Close button to exit the Audio Interface Type
dialog box and return to the Site Channel Configuration List dialog
box.
Audio Board option
If Audio Board was selected (Figure 14), the
Site Channel Configuration dialog box will be displayed. Continue
with channel configuration as described in "Audio Board-Equipped
Channel Configuration."