Ericsson LBI-39224 - Manual (Page 197)

LBI-39224
3-167
COMMAND DEFINITION
SET RX FREQ 7 Set receive frequency to frequency 7.
SET RX FREQ 8 Set receive frequency to frequency 8.
REPEAT ENABLE Enable Repeater.
REPEAT DISABLE Disable Repeater.
CG ENABLE Enable Channel Guard.
CG DISABLE Disable Channel Guard.
CG MON ENABLE Enable Channel Guard Monitor
(disabled on PTTs).
CG MON DISABLE Disable Channel Guard Monitor.
SCAN ENABLE Scan Enable.
SCAN DISABLE Scan Disable.
SIM MON ENABLE Enable simultaneous monitor.
SIM MON DISABLE Disable simultaneous monitor.
Tone Controlled Station
If "Tone" was selected for Control Signaling in the
Conventional Channel Configuration dialog box, choosing the
State Table button will display the Tone Controlled Station
State Table Mapping dialog box, Figure 36. If any changes have
been made and not saved, you will be prompted
(
Write Changes to Disk? ) to save them and display the
Tone Controlled Station State Table Mapping dialog box ( Yes ),
display the Tone Controlled Station State Table Mapping dialog
box without saving ( No ), or cancel the State Table command
( Cancel ) and remain in the Conventional Channel Configuration
dialog box.