Ericsson LBI-39224 - Manual (Page 79)

LBI-39224
3-49
Configured/Active Sites:
The Configured/Active Sites list box displays NIMs which have been
added but not yet channel-configured, NIMs which have had previous
channel configurations performed, and NIMs which have been
previously channel-configured and have an active Controller Board
control data link. Before a site-type interface module can be channel-
configured, it must be listed in the Configured/Active Sites list box.
Any number of the available NIMs may be selected at one time for
modification in the
Site Channel Configuration dialog box. All
selected NIMs in this list will also be included in the " Save As… "
dialog box that is accessed from the Site Channel Configuration
dialog box or the T1/E1 Digital Site Configuration dialog box. See
Table 1 for Configured/Active Sites Prefix Definitions on page 3-25 if
necessary.
Add
Choose the Add button to move a selected NIM from the Configurable
Sites list box and "add" it to the Configured/Active Sites list box where
it can be selected for configuration. If upon adding a NIM, a
configuration data file exists on the CEC/IMC Manager's hard disk
drive from a previous add and delete, the NIM will be added to the
Configured/Active Sites list box with its configuration data file (with a
** prefix). This previous configuration may be modified, saved, and
sent as needed.
Delete
Choose the Delete button to remove ("delete") a selected configured or
unconfigured NIM from the Configured/Active Sites list box to the
Configurable Sites list box. Configured-and-active NIMs cannot be
"deleted." This delete function does not remove NIM channel
configuration files from the CEC/IMC Manager's hard disk drive.
Therefore, if the deleted NIM is subsequently added back to the
Configured/Active Sites list box using the
Add button, the previous
channel configuration is not lost (this configuration data must be re-
saved in the
Site Channel Configuration dialog box before it can be
resent to the CEC/IMC).
Modify
Choose the Modify button and the Audio Interface Type dialog box
will be presented, select either Audio Board or T1/E1 Interface as
required by clicking the appropriate option button. Selecting Audio
Board will activate the
Site Channel Configuration dialog box,