Ericsson LBI-39224 - Manual (Page 23)

LBI-39224
2-1
2. CHAPTER 2
INSTALLATION
2.1 UNPACKING
After opening this package, verify you have received the following:
– CEC/IMC Manager Version 5.0 for Windows NT software—
located on 3-1/2 inch diskettes; this software will be already
installed on the computer's hard drive for a new system
– this manual (LBI-39224)
2.2 CEC/IMC MANAGER REQUIREMENTS
The following minimum hardware and software configuration is
required to operate the CEC/IMC Manager V5.0x.
A. An IBM
®
Compatible PC with a 75 MHz Pentium
®
microprocessor
(or better) running Microsoft ® Windows NT V3.51 (or better) with
the following minimum configuration:
– Service Pack #3 or better installed
– At least 16 Mbytes of RAM
– A 540 Mbyte hard disk
– Two (2) serial ports
B. VGA video card and monitor (or better).
Ensure that the MIGRATE.BAT utility supplied with the
"CEC/IMC Manager Version 5.0 for Windows NT" software
is executed to save that original (DOS) CEC/IMC Manager
configuration BEFORE installing Windows
NT on any
computer already running a DOS version of the CEC/IMC
Manager.
IMPORTANT NOTE!