Ericsson LBI-39224 - Manual (Page 216)

LBI-39224
3-186
prevent overburdening the CEC/IMC Manager's warning system with
auxiliary I/O state change warnings.
An output event state change will be logged with the following warning:
mm/dd/yy hh:mm:ss FF MIM 1 W17-130 Auxiliary I/O - State Change
Output 1 Active [Bit 0 High] Trig: E02-22
The output number, active/inactive state, bit value, absolute state
(high/low) and trigger description will match the current event's data.
The possible "Trig:" descriptions are:
– Console Key Press
– Station Busy
– Select Busy
– Emergency
– Any
Error
– Error
−
Exx-yyy (shown)
– Warning
−
Wxx-yyy
An input event's state change warning is similar except the trigger field
is not displayed.
Read and Delete I/O Event Definitions
Delete
Choose the Delete button to change the selected I/O event from
enabled to modified-not-sent. The selected event remains on the
CEC/IMC Manager hard disk, but is deleted from the CEC/IMC
NOVRAM.
Default
Choose the Default button to return the I/O event entry to the "default"
(unconfigured) condition. If the event is enabled (sent to the
CEC/IMC), it first must be deleted from the CEC/IMC. A confirm
dialog box is displayed which will allow the request to be canceled, if
necessary.
Read Disk
Choose the Read Disk button to view the I/O event configurations
currently stored at the CEC/IMC Manager hard disk.
Save and Send I/O Event Definitions
After the I/O events are defined at the CEC/IMC Manager, the
definitions must be sent to the MOM Controller Board. If the I/O event