Ericsson LBI-39224 - Manual (Page 72)

LBI-39224
3-42
should be the same as the configuration stored on the CEC/IMC
Manager hard disk. If the CEC/IMC Manager hard disk data was
cleared or reset to undesired values,
Read MSC followed by Save
will restore the CEC/IMC Manager hard disk configuration.
Set Defaults
Choose the Set Defaults button to select the pre-programmed default
values from the CEC/IMC Manager hard disk. These values will
replace any currently displayed values; however, these "new" values
must be saved and sent before they will become the new configuration.
T1/E1 Interface Card Auto-configuration
Subrate ports and channel assignments are auto-configured by the
CEC/IMC Manager according to the number of free T1/E1 channels. In
Figure 19, the
T1/E1 Interface Card Auto-configuration dialog box
is shown. Although there are no user configurable fields in this dialog
box, the assignment of subrate ports and T1/E1 channels can be viewed
on a per card basis in this dialog box. Select the card to view from the
drop-down list box in the top left corner.
Figure 19 T1/E1 Interface Card Auto-configuration dialog box
(T1 Line Type Selected)
Help
Choose the Help button to access the Help function. (Help is also
available by pressing the F1 key.)