Ericsson LBI-39224 - Manual (Page 50)

LBI-39224
3-20
TDM bus allocations are performed from the TDM Bus Configuration
dialog box, shown in Figure 11. From the CEC/IMC Manager menu
bar select
Configure System / CEC/IMC Configuration / TDM Bus
to display the TDM Bus Configuration dialog box.
Figure 11 TDM Bus Configuration Dialog Box
Current TDM Bus Configuration
When the
TDM Bus Configuration dialog box is first opened this field
may be blank until the CEC/IMC Manager receives the current TDM
Bus configuration from the CEC/IMC MOM Controller. The current
TDM Bus configuration is then displayed in this read-only field. TDM
bus configuration must match the specific hardware installed
within the CEC/IMC for proper and effective routing of audio
signals.
New TDM Bus Configuration
The number of TDM Buses the CEC/IMC will use to route audio
signals is configured from this field. Select the required number of
TDM Buses from the drop-down list box. TDM bus configuration
must match the specific hardware installed within the CEC/IMC
for proper and effective routing of audio signals.
Number of Slots Remaining
This read-only field displays the current number of TDM time slots
available for assignment (allocation). This number will decrease as
"site" channels are configured and allocated TDM time slots,
conversely this number will increase as channels are "unconfigured."
Changing the number of TDM Buses (above) will have a significant
effect on the number of slots available; increasing the number of buses