Ericsson LBI-39224 - Manual (Page 96)

LBI-39224
3-66
available PIMs may be selected at one time for modification in the
Site Channel Configuration dialog box. All selected PIMs in this list
will also be included in the " Save As… " dialog box that is accessed
from the Site Channel Configuration dialog box or the
T1/E1 Digital Site Configuration dialog box. If necessary, refer to
Configured/Active Sites Prefix Definitions, Table 1, on page 3-25 for
an explanation of the prefixes.
Add
Choose the Add button to move a selected PIM from the Configurable
Sites list box and "add" it to the Configured/Active Sites list box where
it can be configured. If upon adding a PIM, a configuration data file
exists on the CEC/IMC Manager's hard disk drive from a previous add
and delete, the site will be added to the Configured/Active Sites list box
with its configuration data file (with a ** prefix). This previous
configuration may be modified, re-saved and sent as needed.
Modify
Choose the Modify button to display the Audio Interface Type dialog
box, select either Audio Board or T1/E1 Interface as required by
clicking the appropriate option button. Selecting Audio Board will
activate the
Site Channel Configuration dialog box, selecting T1/E1
Interface will activate the T1/E1 Digital Site Configuration dialog
box. These options are discussed in detail in subsequent sections.
Delete
Choose the Delete button to remove ("delete") a selected configured or
unconfigured site from the Configured/Active Sites list box to the
Configurable Sites list box. Configured-and-active sites cannot be
"deleted." This delete function does not remove "site" channel
configuration files from the CEC/IMC Manager's hard disk drive.
Therefore, if the deleted "site" is subsequently added back to the
Configured/Active Sites list box using the
Add button, the previous
channel configuration is not lost (this configuration data must be re-
saved in the
Site Channel Configuration dialog box before it can be
resent to the CEC/IMC).
Close
Choose the Close button to exit the Site Channel Configuration List
dialog box and return to the CEC/IMC Manager main window. Any
"**" (unconfigured and unsaved) PIMs appearing in the