Ericsson LBI-39224 User Manual
Page 255
LBI-39224
4-17
GSC Translation
This option, also accessible from the Diagnostics Options menu, is
similar to the GSC Data option except there is an attempt to translate
the messages into a more readable format. This is similar to the Call
Translation option, except no messages are filtered out. Messages that
cannot be translated are left in the raw hex form. A typical screen is
shown below. Note the header for this option is identical to the Call
Translation header since many messages fall into the same format.
Figure 52 Diagnostics Dialog Box, GSC Translation Option
Selected
GSC Translation should be used when it is desired to view switch/site
status while tracing a problem call if the approximate time is known, for
example: Failsoft state at time of call. This is recommended since even
a very low traffic CEC/IMC will generate more than 3000 messages in
a 15-minute period under these conditions.
The buffer at the MOM controller will wait until it is about
65% full before writing to the data log file. This could mean a
delay of up to 5 minutes between keying a call and the call
showing up in the data log.
NOTE