Ericsson LBI-39224 - Manual (Page 75)

LBI-39224
3-45
"Send to Site Successful" message will be received to confirm that the
data was received by the interface module Controller Board. Bus Slot
configuration data is based on the channel assignment in the Set Site
Channel Disbursement field (one bus slot per channel assigned) and is
compared to the current configuration at the CEC/IMC Manager; if
different, it is sent to the MOM Controller Board (if not, no further
action is taken by the system) and when the MOM Controller Board
receives this new data it will send an acknowledgment message back to
the CEC/IMC Manager, which will then display the confirmation box:
"Do you want to activate TDM Bus Slots? OK - will cause all CTRL
boards to reset." Choose
OK to activate TDM Bus Slots (resetting
Controller Boards) with the new Bus Slot configuration data, choose
Cancel to not activate TDM Bus Slots with the new Bus Slot
configuration data (keeping the previous configuration) and return to
the
T1/E1 Interface Card Auto-configuration dialog box.
T1/E1 Digital Site Configuration dialog box
Save
Choose the Save button to perform an immediate save of the currently
selected site-type interface module's channel configuration. This
channel configuration is saved on the CEC/IMC Manager's hard disk
drive. Any previous channel configuration for the MIM, if present, is
erased and replaced with the current channel configuration. If the
CEC/IMC Manager is running remotely or as a part of the EDACS
Network Manager, this configuration is saved on the CEC/IMC
Manager local to the CEC/IMC; it is not saved at the remote location.
Save As...
Choose the Save As… button to allow the currently selected site-type
interface module channel configurations to be saved as a different site-
type interface module. It is provided to speed configurations when
similar MIM configurations are required. Upon choosing
Save As… a
small dialog box, similar to Figure 17 on page 3-34, will appear which
allows selection of a new MIM number. Select the desired MIM
number from one of the choices in the displayed list, the choices
displayed are the selected MIMs in the Configured/Active Sites list box.
Like
Save , Save As… stores channel configuration on the CEC/IMC
Manager server.
Close
Choose the Close button to exit the T1/E1 Digital Site Configuration
dialog box. If any changes have been made and not saved, a prompt