Ericsson LBI-39224 - Manual (Page 162)

LBI-39224
3-132
Caller
The Unit ID of the console currently utilizing this patch/simulselect.
Site Mask
The sites currently involved in this patch/simulselect. This is a 32 bit
value in hex format, where each bit corresponds to one of the 32
possible sites, i.e. bit 1
⇒
site 1, bit 2
⇒
site 2, etc. The rightmost bit is
bit 1. If the bit is set, the corresponding site has responded with an
"Active" for this patch/simulselect. For example, the value 080E0211
would be in binary format:
0000 1000 0000 1110 0000 0010 0001 0001. Now it is easy to see that
the bits 1, 5, 10, 18, 19, 20, 28 are set, indicating that sites 1, 5, 10, 18,
19, 20, and 28 are active in this patch/simulselect.
Deactivate
Choose the Deactivate button to deactivate a selected
patch/simulselect. The Deactivate command is sent just to those sites
with the active patch/simulselect. The sites then notify the consoles that
the patch/simulselect has been deactivated. This is the preferred
method of deactivating a patch/simulselect.
Delete
Choose the Delete button to delete a selected patch/simulselect.
Delete sends a deactivate command to the sites with the active
patch/simulselect, and also sends the deactivate (delete) command to
the consoles. Patches/simulselects normally should not be deleted or
deactivated using the
Delete button, this should be used only if the
patch/simulselect does not respond to the Deactivate command.
Close
Choose the Close button to exit the Patch and Simulselect View
dialog box and return to the CEC/IMC Manager main window.
3.12 DIGITAL VOICE CHANNEL
CONFIGURATION
In order to support digital voice console dispatch, the CEC/IMC must
be equipped with at least one Digital Voice Interface Module (DVIM).
Each DVIM supports up to thirty-two digital voice channels and there
may be as many as four (4) DVIMs in the CEC/IMC. This section
describes how to configure the available digital voice channels for
console digital voice dispatch to suit your system needs. This will