Ericsson LBI-39224 - Manual (Page 165)

LBI-39224
3-135
Configured/Active Sites Prefix Definitions, on page 3-25 for an
explanation of the different prefixes if necessary.
Add
Choose the Add button to move a selected DVIM from the
Configurable DVIM list box and "add" it to the Configured/Active
DVIM list box where it can be configured. If upon adding a DVIM, a
configuration data file exists on the CEC/IMC Manager's hard disk
drive from a previous add and delete, the DVIM will be added with a
"C" prefix. This previous configuration may be modified, saved and
sent as needed.
Delete
Choose the Delete button to remove ("delete") a selected configured or
unconfigured DVIM from the Configured/Active DVIM list box to the
Configurable DVIM list box. Configured-and-active DVIMs cannot be
"deleted." This delete function does not remove DVIM channel
configuration files from the CEC/IMC Manager's hard disk drive. If the
deleted DVIM is subsequently added back to the Configured/Active
DVIM list box using the
Add button, the previous channel
configuration is not lost.
Channels with a dedicated group will not be undedicated in the
Delete process. Channels should be undedicated (See
Dedicated Channels below) before a DVIM is deleted. Failure
to undedicate these channels before deleting the DVIM may
cause erratic behavior of the CEC/IMC.
Modify
Choose the Modify button to display the
DVIM Channel Configuration dialog box, which is where channel
configuration actually is performed. One or more "sites" must be
selected in the Configured/Active Sites list before the
DVIM Channel Configuration dialog box will be displayed.
3.12.2 DVIM Configuration
This section describes configurations for channels within DVIMs. The
fundamental DVIM channel parameters are permanently set and cannot
CAUTION