Ericsson LBI-39224 - Manual (Page 123)

LBI-39224
3-93
files from the CEC/IMC Manager's hard disk drive. Therefore, if the
deleted CTIM is subsequently added back to the Configured/Active
Sites list box via the
Add button, the previous channel configuration is
not lost (this configuration data must be saved in the
Site Channel Configuration dialog box before it can be resent to the
CEC/IMC).
Close
Choose the Close button to exit the Site Channel Configuration List
dialog box and return to the CEC/IMC Manager main window. Any
"**" (unconfigured and unsaved) CTIMs appearing in the
Configured/Active Sites list box will be removed and returned to the
Configurable Sites list box.
CTIM Audio Board Channel Configuration
This section describes configurations for channels within Audio Board-
equipped site-type interface modules. All channel parameters are
configured from the
Site Channel Configuration dialog box. Only
those CTIMs which were selected in the
Site Channel Configuration List dialog box are available for channel
configuration. Select the desired site-type interface modules to
configure from the Configured/Active Sites list, or add the desired
modules from the Configurable Sites list, if not already listed, as
described earlier. Choose
Modify to display the
Audio Interface Type dialog box, select the Audio Board option
button, (T1/E1 Interface Board is not supported for CTIM) then choose
OK to display the Site Channel Configuration dialog box. The
selected CTIMs are displayed in a list box at the top center of the dialog
box.