ARM Electronics CMS User Manual
Page 84
User’s Manual
83
Refer to the following for description of motion detection settings.
Enable Function:
Check on it to start monitor motion detection.
Motion recording:
Check on it and CMS will record event video when motion
is detected. The length of event video will follow <Event Recording Duration>
specified in Event setting.
Show Motion Detection Region:
Check on it to display the detection area
visually on the monitoring screen. The boxes will also be captured and
displayed on the snapshot images.
Start Simulation:
Click on it to start simulating motion detection. As shown
above, red boxes will mark the motion areas.
Stop Simulation:
Click on it to stop simulation.
Sensitivity:
Setup a desired sensitivity level.
Click on <OK> to apply the settings, or click on <Cancel> to disregard and
return to Live mode.
NOTE:
When motion alert is triggered, an alert icon “
” will be
displayed at bottom-left of the grid.