ARM Electronics CMS - Manual (Page 91)

User’s Manual
90
Record:
Check on it to trigger event recording whenever cross line alert is
detected.
Virtual Line: Click to select this and users can
draw virtual lines at preferred positions. After a
virtual line is drawn, a window will pop up as
shown on the right. Users have to define In/Out
direction and monitoring type. A maximum of 10
virtual lines can be defined for each camera.
Object Size:
After the virtual line is drawn, users need to define size of
detecting object. Click and drag the mouse to define a preferred object size.
Start Simulation: Click on it to start simulating counting application. The
In/Out counter will show numbers of detections.
Stop Simulation:
Click on it to stop simulation.
Clear All:
Click on it to clear all defined virtual lines and the object size box.
Sensitivity: Setup a preferred sensitivity level.
Click on <OK> to apply the settings, or click on <Cancel> to disregard and
return to Live mode.
NOTE:
When cross line alert is triggered, an alert icon “ ” will be
displayed at bottom-left of the grid.