H3C Technologies H3C Intelligent Management Center - Manual (Page 114)

105
Table 20 Required monitoring attributes on the key devices
Devices Monitoring attributes
Router A and Router B
• Response time of device
• Device unreachability proportion
• CPU usage
• Memory usage
• Interface receiving rate
• Interface transmitting rate
• Interface inbound bandwidth usage
• Interface outbound bandwidth usage
• Interface inbound packet loss rate
• Interface outbound packet loss rate
Switch C and Switch D
• Response time of device
• Device unreachability proportion
This section adds monitoring attributes to Router A. You can add monitoring attributes to Router B,
Switch C, and Switch D in the same way. For the required monitoring attributes on each device,
see Table 20 .
To add monitoring attributes to Router A:
1. Click the Resource tab.
2. From the left navigation tree, click Performance Management > Monitoring Settings.
The Monitoring Settings page appears.
3. Click the value in the Instances column of Router A to check whether the required monitoring
attributes are in the Item Name column.
{
If they are displayed in the Item Name column, go to "Creating traffic analysis tasks."
{
If the instance value number is 0, or they are not in the Item Name column, go to the following
steps to add them.
4. Click Add Monitor.
The page for adding monitoring items appears.
5. In the Select Index area, click Add.
a. Select Response Time of Device (ms) and Device Unreachability Proportion (%) from
System-Device Defect.
b. Select CPU Usage (%) from System-CPU Usage.
c. Select Memory Usage (%) from System-Memory Usage.
d. Select the following attributes from System-Interface Statistics.
− Interface Receiving Rate (bps).
− Interface Transmitting Rate (bps).
− Interface Inbound Bandwidth Usage (%).
− Interface Outbound Bandwidth Usage (%).
− Interface Inbound Packet Loss Rate (%).
− Interface Outbound Packet Loss Rate (%).
e. Click OK.