H3C Technologies H3C Intelligent Management Center User Manual
Page 119
110
5.
Configure basic parameters for the NQA instance:
a.
NQA Instance Name—Enter Mail link (Router A to Router B).
b.
Group—Select 001.
c.
NQA Instance Description—Enter monitor the link between Router A and Router B.
d.
NQA Level Name—Select Gold Service Level.
e.
NQA Type Name—Select Link for Mail Service.
6.
Click Next.
The page for configuring deployment information appears.
Figure 44 Configuring deployment information
7.
Configure the following parameters:
a.
Source Device—Select Router A.
b.
Destination Device—Select Router B.
c.
Source IP Address—Select the source IP address for NQA operations.
d.
Destination IP Address—Select the destination IP address for NQA operations.
Use the default settings for other parameters.
8.
Click Test to check whether the NQA instance is correctly configured.
If the test fails, modify the parameters that you have configured in
9.
Click Next.
The page for configuring monitor information appears. Use the default settings on the page.