Creating nqa instances for link monitoring – H3C Technologies H3C Intelligent Management Center User Manual
Page 116
107
e.
In the Device information area, select Router A.
f.
Click Deploy.
4.
Add a traffic analysis task:
a.
Access the Settings page.
b.
Click Traffic Analysis Task Management.
c.
Click Add.
The Select Task Type page appears.
d.
Select Interface, and click Next.
The Add Traffic Analysis Task page appears.
e.
Configure the traffic analysis task:
−
In the Task Name field, enter interface.
−
In the Reader field, select Administrator Group, Maintainer Group, and Viewer Group.
−
In the Interface Information area, click Select, and then select GigabitEthernet1/0/10.
Use the default settings for other parameters on the page.
f.
Click OK.
For more information about NTA, see HP IMC NTA Administrator Guide.
Figure 41 Configure the traffic analysis task
Creating NQA instances for link monitoring
Before you create NQA instances, make sure Router A, Router B, Switch C, and Switch D support both
SNMP and NQA.
To monitor the quality of the key links, you must create six NQA instances that use the ICMP echo, UDP
echo, and TCP connection operations. Every two NQA instances between the two devices monitor the
operation in different directions.
This section creates an NQA instance from Router A to Router B. You can create the other five NQA
instances in the same way.