HEIDENHAIN TNC 360 ISO Programming - Manual (Page 124)

5-41 TNC 360
5 Programming Tool Movements
G 7
G 9
X 5
1 0
0
5 0 F
END
I
5.7 Positioning with Manual Data Input (MDI)
In the POSITIONING WITH MANUAL DATA INPUT mode of operation you
can use G07 to enter and execute single-axis positioning blocks. The
entered positioning blocks are not stored in the TNC memory.
Application examples:
• Pre-positioning
• Face milling
POSITIONING MANUAL DATA INPUT
Select the MDI function.
Select a single axis positioning block.
For example: Select programming absolute values.
For example: Position in X at 5 mm.
For example: Feed rate F=1500 mm/min; terminate the block.
Start the positioning block.