Parameters for machining and program run -7 – HEIDENHAIN TNC 360 ISO Programming User Manual
Page 206
1 1 - 7
TNC 360
11
Tables, Overviews, Diagrams
11.1 General User Parameters
Display steps for coordinate axes
MP7290
Function
Value
• Display step 0.001 mm .................................................................................................................................... 0
• Display step 0.005 mm .................................................................................................................................... 1
Q parameters and status display
MP7300
Function
Selections
Value
• Q parameters and status display
Do not erase ................................................................................. +0
Erase with M02, M30 and N9999 ................................................ +1
• Last programmed tool after
Do not activate ............................................................................. +0
power interruption
Activate ........................................................................................ +4
Graphics display
Entry range: 0 to 3 (sum of the individual values)
MP7310
Function
Selections
Value
• View in 3 planes
Projection method 1 .................................................................... +0
according to ISO 6433, Part 1
Projection method 2 .................................................................... +1
• Rotate coordinate system
Rotate ........................................................................................... +2
by 90° in the working plane
Do not rotate ................................................................................ +0
Parameters for machining and program run
Effect of cycle G72 SCALING
MP7410
Function
Value
• SCALING effective in 3 axes ............................................................................................................................ 0
• SCALING effective in the working plane ......................................................................................................... 1
MP7411 Tool compensation data in the TOUCH PROBE block
Function
Value
• Overwrite current tool data with the calibrated data of the touch probe ......................................................... 0
• Retain current tool data .................................................................................................................................... 1