HEIDENHAIN TNC 360 ISO Programming - Manual (Page 208)

1 1 - 9 TNC 360
11 Tables, Overviews, Diagrams
11.1 General User Parameters
Safety limit for machining corners at constant path speed
Corners whose inside angle is less than the entered value are no longer
machined at constant path speed with M90.
MP7460
Function Value
• Maintain constant path speed at inside corners for angles of (degrees) ...................................... 0 to 179.999
Coordinate display for rotary axis
MP7470
Function Value
• Angle display up to ± 359.999° ........................................................................................................................ 0
• Angle display up to ± 30 000° .......................................................................................................................... 1
Parameters for override behavior and electronic handwheel
Override
Entry range: 0 to 7 (sum of the individual values in the “value” column)
MP7620
Function Selections Value
• Feed rate override when rapid traverse Override effective ............................................................. +1
key pressed in program run mode Override not effective ....................................................... +0
• Feed rate override when rapid traverse key Override effective ............................................................. +4
and machine axis direction button pressed Override not effective ....................................................... +0
• Increments for overrides 1% increments ................................................................. +0
0.01% increments ............................................................ +8