Solare Datensysteme Solar-Log - Manual (Page 108)

108
Configuring Notifications
20�2 Device notifications
If certain status or fault codes occur, Solar-Log™ can send messages by e-mail or text message (SMS).
The Solar-Log™ retrieves fault messages from the connected inverters. Therefore, the status and fault
codes can vary depending on the inverters installed.
The codes are always divided into two groups.
Fig.: Status and fault code groups
In group A, inverter specific messages are numbered in ascending order, starting with 0. The code which is
automatically determined is used for the filter function.
In group B, the actual messages from the inverters are displayed. The meaning of these fault messages can
be found in the particular manufacturer's manual.
Note
When making support inquiries with the inverter manufacturer, please use the mes-
sages from group B .
Open the dialog box
Select Configuration | Notifications | Device messages from the menu
This is divided into the following sections:
•
Device
•
Status codes
•
Fault codes
•
Filter
Status and fault codes
The status and fault codes that are available depend on the inverter type. To find out which status and
fault codes are relevant for automatic messaging, please refer to the inverter user manual.