Solare Datensysteme Solar-Log - Manual (Page 182)

182
Direct Device Configurations (Solar-Log 1000)
How to change the pulse factor:
•
Touch the input box for the Pulse Factor
The virtual keyboard appears.
•
Enter the desired pulse factor and confirm with OK.
•
Touch Save and then Next to go to the next dialog.
Setting up SO meters
This sub dialog box is available only if a power meter is connected to Solar-Log 1000 and has been se-
lected.
The S0 meter is flexible and can be set in 3 modes:
•
in Inverter mode for inverters with data protocols that are not supported
•
as Overall yield meter to count the total output from the entire plant
•
as Consumption meter to visualize and to calculate the system's own consumption rate.
Connected module power
A value for the connected module power is needed in inverter mode, in order to make power comparisons
between the different inverters and offset them against each other.

Module field (1-9)
In the module field, the same types of strings are placed together for plant monitoring and to be monitored
together. For a roof with equal modules, which have the same alignment and the same angle of inclination
on the roof, all strings are assigned to module field "1". If there are other inverters connected, which are
operatingwith a different roof alignment, these strings are given the module field number "2" etc.
Procedure
•
Enable required mode Inverter mode, Overall yield meter or Consumption meter.
•
Touch the input box for the Connected Module Power
The virtual keyboard is displayed.
•
Enter the desired module power and confirm with OK.
•
Touch the input box for the module field
The virtual keyboard appears.
•
Enter the number of the module field and confirm with OK.
•
Touch Save and then Next to go to the next dialog.
Setting the module and power data
Dialog for standard inverters
In standard inverters, the individual strings are interconnected internally.
Connected module power
A value for the connected module power at the inverter is needed in order to make power comparisons
between the different inverters and offset them against each other.
How to enter the module and power data:
•
Touch the input box for the Connected Module Power
The virtual keyboard is displayed.
•
Enter the desired module power and confirm with OK.
•
Touch the input box for the module field
The virtual keyboard appears.