Solare Datensysteme Solar-Log - Manual (Page 68)

68
Installation
14�2�1 Carrying out the initial set up of the Solar-Log 200 and 300
The initial configuration of Solar-Log 300 is made via the web browser menu.
Procedure:
•
Enter the address http://solar-log in the address bar of the web browser.
•
A selection of display languages is displayed.
•
Select the desired Display Language .
•
The welcome screen then appears.
•
In the navigation bar at the top, click on Configuration
•
The following menus have to be configured:
Internet (Chapter „17 Internet Configuration“)
Network (Chapter “16.1 Configuring network settings” on page 75)
Device (Chapter “18 Configuring connected devices” on page 88)
Plant (Chapter “19 Configuring Plant Data” on page 101) and
System (Chapter “22 System Configuration” on page 121).
14�3 Initial set up of the Solar-Log 1200
The initial configuration of Solar-Log 1200 can be made via a Web browser or via the touch display.
Requirements
•
All cables and accessories (if any) have been connected to the Solar-Log 1200 .
•
The Solar-Log 1200 is connected to an Internet router.
•
The DHCP service is enabled on the Internet router.
•
The DHCP service is also enabled on the PC or laptop.
Easy Installation
After selecting the language and country, the initial set up can be carried out with the "Easy Installation"
configuration wizard. However, Easy Installation can currently only be used with certain inverters. Depend-
ing on the country, different inverter brands are integrated into the Easy Installation mode.
The Solar-Log TM then carries out the initial set up intuitively step by step.
For more information, please refer to the Quick Start Guide that was included with the device.