Efficient Networks 107-0001-000 - Manual (Page 144)

Chapter 5: Ethernet Interface Commands Efficient Networks ® Router family
Command Line Interface Guide
Page 5-6 Efficient Networks
®
eth delete
Deletes a logical interface from an Ethernet port. For more information, see “ IP
Subnets” on page 6-1 of the Technical Reference Guide.
When a logical interface is deleted, all information defined for that interface, such as
routes and filters, is deleted automatically.
NOTE:
This command takes effect immediately; however, if the change is not saved before
the next reboot, the deletion is lost and the deleted interface reappears after the
reboot.
Once defined, routes and filters can be created for the new logical interface using the
other eth commands in this section. To list the currently defined logical interfaces, use
the
eth list command. To remove a logical interface, use an eth delete command.
Mgmt Class
Network (R/W)
Input Format
eth delete <port#>:<logical#>
Parameters
Example
In the following example, logical interface 1 is deleted from Ethernet port 0:
Response
Command prompt.
<port#>
a
a 0 for a single-port router; 0 or 1 for a dual-port router.
Ethernet interface from which logical port will be deleted
<logical#>
b
b Integer, value cannot = 0; logical interface 0 always exists.
Logical interface number to be deleted.
-> eth delete 0:1