Efficient Networks 107-0001-000 - Manual (Page 155)

Efficient Networks ® Router family
Command Line Interface Guide
Chapter 5: Ethernet Interface Commands
Efficient Networks
®
Page 5-17
Parameters Cont.
Response
Command prompt.
<protocol> Protocol used by the selected server.
<protocolid>
a
a
Integer
Numerical protocol ID.
tcp TCP only.
udp UDP only.
all All protocols.
<first port> First or only port as seen by the Ethernet interface. Port used by
the selected server.
<portid>
b
b
Integer, 0 - 65,535
Numerical port value; a value of 0 matches
any port.
ftp File Transfer Protocol (FTP) port.
h323 H.323 port.
http Hypettext Transfer Protocol (HTTP) port.
smtp Simple Mail Transfer Protocol (SMTP) port.
snmp Simple Network Management Protocol (SN-
MP) port.
t120 T.120 port.
telnet Telnet port.
tftp Trivial File Transfer Protocol (TFTP) port.
all All ports.
<last port> Optional, last port in the range of ports as seen by the remote
end for the server on the LAN.
<first private
port> c
If specified, this is a port remapping of the incoming requests
from the Ethernet interface.
<interface>
a
,
c,d
c This parameter may be omitted if the router has only one Ethernet interface.
If the router has two physical Ethernet interfaces (an Ethernet hub router), the port number (0 or 1) must
be specified.
d
To specify a logical interface other than logical interface 0, specify both the port number and the logical
interface number (<port #>:<logical #>, for example, 0:1).
Ethernet interface.