Efficient Networks 107-0001-000 - Manual (Page 171)

Efficient Networks ® Router family
Command Line Interface Guide
Chapter 5: Ethernet Interface Commands
Efficient Networks
®
Page 5-33
Parameters
Example
Response
Command prompt.
eth ipx addr
Sets the IPX network number for the Ethernet LAN connection.
Mgmt Class
Network (R/W)
Input Format
eth ipx addr <ipxnet> [port#]
Parameters
Response
Command prompt.
eth ipx disable
Disables IPX routing across the Ethernet LAN. This acts as a master switch allowing
you to disable IPX routing for testing or control purposes.
<vrid>
a
a
Integer, 1 - 255
Virtual route ID.
<interface>
b
b
To specify a logical interface other than 0:0, specify both the port number (0 or 1) and the logical
interface number using the format <port #>:<logical #> (for example, 0:1).
Ethernet interface. The default value is 0:0.
This command example assigns VRID 7 to the logical Ethernet interface 0:1.
-> eth ip vrid 7 0:1
This command example clears the VRRP interface designation from interface 0:1.
-> eth ip vrid 0 0:1
<ipxnet>
a
a
8 hexadecimal characters.
IPX network number.
<port>
b
b
Integer, 0, 1 or it may be omitted.
Port number of the Ethernet LAN.