Efficient Networks 107-0001-000 - Manual (Page 236)

Chapter 6: Remote Commands Efficient Networks ® Router family
Command Line Interface Guide
Page 6-48 Efficient Networks
®
Parameters Cont.
Response
Command prompt.
remote setipslaveppp
Sets the IP Slave PPP mode. If the slave mode is yes, the router accepts the IP
address that the remote end informs the router that it has; the router disregards any
IP address specified in its own configuration. If the mode is no, the router tries to use
the address in its configuration.
Normally there is no need to change the default (no) value of this option. However, in
certain situations where the router is managed by another party, (as part of a
managed service), you could set this value to yes to ensure that the central
management site always specifies the IP address of the router.
Mgmt Class
Network (R/W)
Input Format
remote setipslaveppp yes | no <remotename>
Parameters
Response
Command prompt.
multicast Allows the remote router to forward IP multicast traffic.
lanconfig Accept LAN configuration information. Indicates that this PPP
remote can receive IPCP information for dynamically recon-
figuring the Ethernet interface.
lcpecho Use periodic echo.
<routername>
a
a
ASCII string
Name of the remote router
yes | no Slave mode setting. The default is no.
<remotename>
a
a
ASCII string
Name of the remote router.