Efficient Networks 107-0001-000 - Manual (Page 341)

Efficient Networks ® Router family
Command Line Interface Guide
Chapter 9: L2TP Commands
Efficient Networks
®
Page 9-11
Input Format
l2tp set hiddenAVP yes | no <tunnelname>
Parameters
Response
Command prompt.
l2tp set ouraddress
Specifies the source IP address used when the tunnel is originated.
Use this command when you want to specify a source IP address other than the WAN
interface IP address. For example, if NAT (network address translation) is not being
used, all IP addresses on the Ethernet LAN would be visible. You could then specify,
as the source IP address, the Ethernet IP address of the router (which would be
visible) instead of the WAN interface IP address.
Mgmt Class
Security (R/W)
Input Format
l2tp set ouraddress <ipaddr> <tunnelname>
Parameters
Response
Command prompt.
yes Allows the router hide AVPs. Default value.
no Disables hidden AVPs.
<tunnelname>
a
a ASCII string
Name of the tunnel.
b
b The name is case sensitive.
<ipaddr>
a
a
Dotted-decimal notation.
Source IP address used for this tunnel.
<tunnelname>
b
b
ASCII string
Name of the tunnel.
c
c
The name is case sensitive.