Idsl set switch, Mgmt class, Input format – Efficient Networks 107-0001-000 User Manual
Page 289: Parameters, Response, Remote setdlci, Idsl set switch -29 remote setdlci -29, Use the
Chapter 7: WAN Interface Commands
Efficient Networks
®
Page 7-29
idsl set switch
Specifies link speeds of 64, 128, or 144 Kbps for the IDSL connection.
Mgmt Class
Network (R/W)
Input Format
idsl set switch FR64 | FR128 | FR144
Parameters
Response
Command prompt.
remote setdlci
This command sets the DLCI for the remote router entry. The DLCI (Data Link
Connection Identifier) is an address identifying a logical connection in a Frame Relay
environment. The DLCI is generally provided by the Network Service Provider.
The IDSL router can support several DLCI virtual circuits over a Frame-Relay IDSL
link. However, a typical connection to the Internet requires only one DLCI. The DLCI
number must match the DLCI of the remote end.
Mgmt Class
Network (R/W)
Input Format
remote setdlci <dlcinumber> <remotename>
FR64
Link speed of 64 Kbps
FR128
Link speed of 128 Kbps
FR144
Link speed of 144 Kbps