Efficient Networks 107-0001-000 - Manual (Page 229)

Efficient Networks ® Router family
Command Line Interface Guide
Chapter 6: Remote Commands
Efficient Networks
®
Page 6-41
Mgmt Class
Network (R/W)
Input Format
remote setatmnasp atmf | e164 partial | full <nsap>
<remotename>
Parameters
Response
Command prompt.
remote setauthen
Sets the authentication protocol used communicate with the remote router. The
authentication protocol is the minimum security level that the target router must use
with the remote router; this level is verified during security negotiation. The router will
always attempt to negotiate the highest level of security possible (CHAP). The router
will not accept a negotiated security level less than this minimum authentication
method.
The parameter in the remote router database is used for the local side of the
authentication process; this is the minimum security level used by the target router
when it challenges or authenticates the remote router.
Mgmt Class
Security (R/W)
Input Format
remote setauthen <protocol> <remotename>
atmf ATM forum encoding.
E164 ITU E164 encoding.
partial The MAC address of the router is substituted for octets 2-7 of
the NSAP.
full No change is made to the specified NSAP.
<nsnap>
a
a
specified as 40 hex digits or 20 octets (2-digit pairs separated by colons
NSAP