Efficient Networks 107-0001-000 - Manual (Page 169)

Efficient Networks ® Router family
Command Line Interface Guide
Chapter 5: Ethernet Interface Commands
Efficient Networks
®
Page 5-31
eth ip unbindroute
Removes an Ethernet route from the named IP virtual routing table. To list the routes,
use the command
iproutes . To add an Ethernet route to a virtual routing table, use the
command eth ip bindroute .
NOTE:
A route change in an IP virtual routing table takes effect immediately. However, the
change is lost if it is not saved before the next reboot.
To list the current management address for the Ethernet interface, if any, use the eth
list command. To set a management address for the WAN interface, see remote
setmgmtipaddr .
Mgmt Class
Network (R/W)
Input Format
eth ip unbindroute <ipaddr> <tablename> [<interface>]
Parameters
Example
The following commands remove Ethernet routes from virtual routing table ROSA.
The first deleted route is for IP address 10.1.2.0 and the default Ethernet interface
(0:0). The second deleted route is for IP address 10.1.3.0 and the logical Ethernet
interface 0:1
Response
Command prompt.
<ip addr>
a
a Dotted-decimal notation
Ethernet LAN IP address.
<tablename>
b
b ASCII string
IP virtual routing table from which the route is removed.
<interface>
c,d
c
This parameter may be omitted if the router has only one Ethernet interface. If the router has two
physical Ethernet interfaces (an Ethernet hub router), the port number (0 or 1) must be specified.
d
To specify a logical interface other than logical interface 0, specify both the port number and the logical
interface number (<port #>:<logical #>, for example, 0:1).
Ethernet interface.
-> eth ip unbindRoute 10.1.2.0 ROSA
-> eth ip unbindRoute 10.1.3.0 ROSA 0:1