Efficient Networks 107-0001-000 - Manual (Page 146)

Chapter 5: Ethernet Interface Commands Efficient Networks ® Router family
Command Line Interface Guide
Page 5-8 Efficient Networks
®
eth ip addr
Defines the IP address and subnet mask for an Ethernet port or logical interface.
Mgmt Class
Network (R/W)
Input Format
eth ip addr <ipaddr> <ipnetmask> [<interface>]
Parameters
Example
The following command sets the IP address and subnet mask for the default Ethernet
interface (0:0):
The following command sets the IP address and subnet mask for logical interface 1
on Ethernet port 0:
Response
Command prompt.
<ip addr>
a
a
Dotted-decimal notation
Ethernet LAN IP address.
<ipnetmask> a IP network mask.
<interface>
b,c
b
This parameter may be omitted if the router has only one Ethernet interface.
If the router has two physical Ethernet interfaces (an Ethernet hub router), the port number (0 or 1) must
be specified.
c
To specify a logical interface other than logical interface 0, specify both the port number and the logical
interface number (<port #>:<logical #>, for example, 0:1).
Ethernet interface.
-> eth ip addr 192.168.1.254 255.255.255.0
-> eth ip addr 10.0.27.1 255.255.255.0 0:1