Efficient Networks 107-0001-000 - Manual (Page 181)

Efficient Networks ® Router family
Command Line Interface Guide
Chapter 5: Ethernet Interface Commands
Efficient Networks
®
Page 5-43
eth vrrp list
Lists the VRRP attribute records for the port and shows the status of the VRRP router.
For more information, see “
VRRP Backup” on page 6-16 of the Technical Reference
Guide.
Mgmt Class
Network (R)
Input Format
eth vrrp list [<port#>]
Parameters
Response
Typical response listing the attribute records for the default port 0.
eth vrrp set multicast
Changes the multicast address used for VRRP router announcements. This address
is used by all VRRP announcements from this router, regardless of VRID or port. For
more information, see “
VRRP Backup” on page 6-16 of the Technical Reference
Guide.
NOTE:
This command is not usually needed for VRRP configuration. Do not use this
command unless you clearly understand its impact.
NOTE:
This command takes effect immediately, but you must save the change if it is to
persist after you restart the interface or reboot the router.
<port#>
a
a The default is 0; the parameter may be omitted if the router has only one port.
Physical Ethernet interface (port) number.
-> eth vrrp add 7
VRRP Records for Ethernet Port. 0
VRRP Record................... VRID 8, Priority 100, Interval 1
Flags: preempt, No Authentication
Interface: ETHERNET/0:3
Primary WAN interface is down