Firewall setudpfloodthreshold, Mgmt class, Input format – Efficient Networks 107-0001-000 User Manual
Page 483: Parameters, Response, Firewall viewdroppkts, Firewall setudpfloodthreshold -17, Firewall viewdroppkts -17, Firewall setudpflood- threshold
Chapter 18: Stateful Firewall Commands
Efficient Networks
®
Page 18-17
firewall setudpfloodthreshold
As a method to prevent a flooding of the system with User Datagram Protocol (UDP)
packets, use this command set the threshold value for the number of UDP packets
per second. When the specified threshold is exceeded, the firewall will block any
subsequent UDP packets until the UDP traffic drops below the threshold value. For
more information on UDP attacks, see “
Stateful Firewall” on page 4-34.
Mgmt Class
Security (R/W)
Input Format
firewall setudpfloodthreshold <number>
Parameters
Response
Command prompt.
firewall viewdroppkts
Displays a listing of up to 200 of the most recent dropped packets.
Mgmt Class
Security (R/W)
Input Format
firewall viewdroppkts <number>
Parameters
<number>
a
a
Integer (1000)
Threshold value in packets per seconds.
<number>
a
a
Integer 1 - 200 (200)
Specifies the number of dropped packets to display.