Ricoh MIB-II - Manual (Page 103)

Operating Instructions Administrator Reference
103
2. Menu Buttons
Buttons to configure the Network Interface Board
and confirm the status of the printer.
Note
❒ When you click [ Network Config ], a dialog
box appears requesting the user name and
a password. Type only the password in this
dialog box. The factory default password is
"password".
❒ The password is the same as that used for
remote maintenance and that used in the
NIB Setup Tool. If you change a password
with the Web browser, other passwords are
also changed.
3. Status
Displays the name and comments of the Network
Interface Board, and the printer status.
Configuring the Network Interface Board Settings
AAAA
Start the Web browser.
BBBB
Point your browser at the URL or IP address of the printer (e.g. http://XXX.XXX.XXX.XXX
where the Xs are the number of the IP address).
The status of the printer you chose appears on the Web browser.
CCCC
Click [ Configuration ] .
The dialog box for entering the password and user name is displayed.
DDDD
Enter your user name and password, and then click [ OK ] .
To use the factory default account, enter no user name and type "password" for the password.