Ricoh MIB-II - Manual (Page 219)

Operating Instructions Administrator Reference
219
Message List
This is a list of messages written in the printer's system log. The system log can be viewed using the
syslog command.
System Log Information
You can use the following methods to view the system log.
• telnet : Use the syslog command. See p.184 “Commands List” .
Message Description and Solutions
Access to NetWare server <file server name> denied. Ei-
ther there is no account for this print server on the Net-
Ware server or the password was incorrect. (In print server mode) Cannot log in to the file server.
Make sure that the print server is registered on the file
server. If a password is specified for the print server, de-
lete it.
add_sess: community<community name> already defined. The same community name already exists. Use another
community name.
add_sess: session<community name>already defined. A requested community name is not defined.
add_sess: bad trap addr:<IpAddress>, community:
<community name> The IP address (0.0.0.0.) is unavailable when the commu-
nity access type is TRAP. Specify the host IP address for
the TRAP destination.
add_sess_ipx: bad trap addr: <IPX address>, community:
<community name> The IPX address (00:00:00:00:00:00) is unavailable
when the community access type is TRAP. Specify the
host IPX address for the TRAP destination.
add_sess_ipx: community <community name> already
defined. The same community name already exists. Use another
community name.