Ricoh MIB-II - Manual (Page 205)

Operating Instructions Administrator Reference
205
Changing the Password
Use the passwd command to change the remote maintenance password.
Important
❒ Be sure not to forget or lose the password.
Note
❒ The default factory password is "password".
AAAA
Type "passwd".
msh> passwd
BBBB
Type the current password.
Old password:
CCCC
Type the new password.
New password:
Note
❒ The password must consist of 3 to 8 alphanumeric characters and symbols. Upper and lower
case characters are considered unique. For example, R is different from r.
❒ The password is the same as that used in the configuration of the Network Interface Board using
a Web browse and that used in the NIB Setup Tool. If you change a password from telnet, other
passwords are also changed.
DDDD
Type the new password once again.
Retype new password: