Configuring the printer, Configuring a windows 2000 computer, Operating instructions administrator reference – Ricoh MIB-II User Manual

Page 15

Advertising
background image

Operating Instructions

Administrator Reference

15

Configuring the printer

Configure the printer to use the TCP/IP protocol.

Confirm that the TCP/IP protocol is set to be active. (The factory default is active.)

Assign an IP address and make other settings required for using the TCP/IP protocol.

Reference

For more information about how to make the above settings, see "Windows 2000 Configuration" in
Printer Client Reference that comes with this printer.

If DHCP is used to assign IP addresses, see

p.231 “Using DHCP”

.

Note

After setting the IP address, use the ping command to confirm that it has been set correctly.

A

Click [

Start

], point to [

Programs

], point to [

Accessories

] and then click [

Command Prompt

].

B

Type the following: (Example IP address is 192.168.15.16)

C:> ping 192.168.15.16

If the address has been configured correctly, the following message appears.

Reply from 192.168.15.16

If the address has been configured incorrectly, the following message appears.

Request timed out.

Configuring a Windows 2000 computer

Follow these steps to configure a Windows 2000 computer to use the TCP/IP protocol.

AAAA

Click

[

Start

]

on the taskbar, point to

[

Settings

]

, and then click

[

Network and Dial-up Connections

]

.

BBBB

Click

[

Local Area Connection

]

. On the

[

File

]

menu, click

[

Properties

]

.

Advertising