Ricoh MIB-II - Manual (Page 16)

Operating Instructions Administrator Reference
16
CCCC
Confirm that "Internet Protocol (TCP/IP)" is selected in the [ Components checked are used by
this connection: ] box under the [ General ] tab.
Note
❒ If the check box for TCP/IP protocol is not selected, select the box.
❒ If the TCP/IP protocol is not installed, click [ Install ] under the [ General ] tab and install it. For more
information about installing the TCP/IP protocol, see Windows 2000 Help.
DDDD
Configure the TCP/IP protocols with an appropriate IP address, subnet mask and other set-
tings.
Confirm with the network administrator that the settings are correct.
Configuring NetBEUI for Printing
Follow these instructions to configure the Network Interface Board and Windows 2000 to use the Net-
BEUI protocol.
Configuring the printer
Configure the printer to use the NetBEUI protocol.
• Confirm that the NetBEUI protocol is set to be active. (The factory default is active.)
Reference
For more information about how to make the above settings, see "Windows 2000 Configuration" in
Printer Client Reference that comes with this printer.