Ricoh MIB-II - Manual (Page 55)

Operating Instructions Administrator Reference
55
Configuring a Windows NT computer
Install the NetBEUI protocol on the Windows NT computer, and change the LAN adapter number (La-
na Number).
AAAA
Open [ Control Panel ] and double-click the [ Network ] icon. Confirm that "NetBEUI Protocol" is
listed in the [ Network Protocols ] box under the [ Protocols ] tab.
Note
❒ If the NetBEUI protocol is not installed, click [ Add... ] under the [ Protocols ] tab, and install it. For
more information about installing the NetBEUI protocol, see Windows NT Help.
BBBB
Change the Lana Number. Click the [ Services ] tab, click "NetBIOS Interface" in the [ Network
Services: ] box , and then click [ Properties: ] .
CCCC
Click the Lana Number corresponding the Nbf protocol of the [ Network Route ] headline, and
then click [ Edit ] .
DDDD
Type "0" as the Lana Number.
Note
❒ If another protocol’s Lana Number is configured at “0”, change it to another number other than
“0”.
EEEE
Click [ OK ] .
FFFF
Click [ Close ] , and then close the [ Network ] dialog box.
GGGG
After confirming the message to restart, click [ Yes ] .
Note
❒ After you change the Lana Number, you must restart the computer.