Ricoh MIB-II - Manual (Page 196)

Operating Instructions Administrator Reference
196
Direct Printing Port
The direct printing port allows printing directly from a computer, connected to the network, to the printer.
Use the diprint command to change the direct printing port settings.
❖ ❖ ❖ ❖ View settings
The following command displays the current direct printing port settings.
msh> diprint
Example output:
port 9100
timeout=300(sec)
bidirect off
• The “Port” specifies the port number of the direct printing port.
• The “bidirect” setting indicates whether the direct printing port is bidirectional.
❖ ❖ ❖ ❖ Setting timeout
You can specify the timeout interval to use when receiving data from the network.
msh> diprint [0~65535]
Note
❒ The factory default is 300 seconds.
❒ If 0 is set, timeout is disabled.
❖ ❖ ❖ ❖ Bidirectional configuration for the direct printing port
Use this setting to configure whether the direct printing port is bidirectional.
The factory default is “off”.
msh> diprint bidirect {on|off}