Autonet, Operating instructions administrator reference – Ricoh MIB-II User Manual
Page 202
Operating Instructions
Administrator Reference
202
❖
❖
❖
❖ Viewing setting
The following command displays the WINS server IP address.
msh> wins
Example out put:
wins: primary server 0.0.0.0 secondary server 0.0.0.0
Note
❒
If DHCP is used to start from the network, the current WINS server address is displayed. This
address, however, is not displayed if DHCP is not used.
❒
If the IP address obtained from DHCP differs from the WINS IP address, the DHCP address is
the valid address.
❖
❖
❖
❖ Address configuration
Use this command to configure a WINS server IP address.
msh> wins {primary|secondary} IP_address
Note
❒
Use the "primary" to configure a primary WINS server IP address.
❒
Use the "secondary" to configure a secondary WINS server IP address.
AutoNet
Use the set command to configure Autonet.
Note
❒
For more information about Autonet, see
.
msh>set autonet {on|off}
Select "on" to activate Autonet, and "off" to deactivate it.