Printing after resetting the printer, Using dhcp, Operating instructions administrator reference – Ricoh MIB-II User Manual
Page 231
Operating Instructions
Administrator Reference
231
•
With Windows 2000, clear the
[
Enable banner
]
check box under the
[
NetWare Settings
]
tab in the
Printer Properties dialog box.
•
With Windows NT 4.0, clear the
[
Enable banner
]
check box under the
[
NetWare Settings
]
tab in the
Printer Properties dialog box.
Printing after resetting the printer
After resetting the remote printer, it will be cut off from the print server for about 30-40 seconds before
connecting again. Due to the NetWare specification, print jobs may be accepted, but they will not be
printed during this interval.
When using the printer as a remote printer, wait about 2 minutes after resetting the printer before at-
tempting to print.
Using DHCP
You can use the printer under a DHCP environment. You can also register the printer NetBIOS name
on a WINS server when it is running.
Limitation
❒
DHCP cannot be used with IEEE 1394 (IP over 1394). Set a fixed IP address with the control panel,
telnet or a Web browser.
•
See the Setup Guide.
•
See
•
See