Ricoh MIB-II - Manual (Page 184)

Operating Instructions Administrator Reference
184
DDDD
Exit telnet.
msh> logout
When the configuration is changed, a confirmation message requests whether or not the changes
should be saved.
EEEE
Type "yes" to save the changes, and then press
{{{{Enter}}}}.
If you do not want to save the changes, type "no", and then press {{{{Enter}}}}. If you want to make ad-
ditional changes, type "return" at the command line, and then press
{{{{Enter}}}}.
Note
❒ If the "Can not write NVRAM information" message appears, the changes are not saved. Repeat
the steps above.
❒ The Network Interface Board is reset automatically when the settings are changed.
❒ When the Network Interface Board is reset, the active print job which has already been sent to
the printer will finish printing. However, jobs that have not been sent yet will be canceled.
Commands List
This is a list of commands that can be used via remote maintenance.
Note
❒ Type "help" to see a list of commands that can be used.
msh> help
❒ Type "help command_name" to display information about the syntax of that command.
msh> help command_name